Application : HRM、JLM vertical mill
Publishdate：2021-06-07 Views：234
Product characteristics:
Entire grinding roller is combined with refractory oxide layer,hi-chrome and SG basic. Moreover, the wear segment owns three layers that are refractory oxide,chrome and SG basic. But the grinding table has not SG basic. The advantage of which are the structure can both keep the hardness of abrasion and the resilience of steel to avoid cracking and breakage.it is effective to reduce the impact when it is in operation. After heat treatment comprehensively that can meet the requirement of the hardness in working environment.
Advantages of the sintercast:
1,No risk of casting breakage during operation
2,Original profile can be maintained for much longer time and due to which performance will be
consistent.
3,Sinter layer will be harder than hard facing layer and create uniform wear on the casting, it
reduces the power consumption
4,Reduce the stoppage for in situ hard facing and minimize the risk of production less and direct
revenue generation
5,Much less wear rate as compared to hard facing and twice or triple much higher wear life.
6,Reduce the maintenance and operating cost
Product characteristics:
Entire grinding roller is combined with refractory oxide layer,hi-chrome and SG basic. Moreover, the wear segment owns three layers that are refractory oxide,chrome and SG basic. But the grinding table has not SG basic. The advantage of which are the structure can both keep the hardness of abrasion and the resilience of steel to avoid cracking and breakage.it is effective to reduce the impact when it is in operation. After heat treatment comprehensively that can meet the requirement of the hardness in working environment.
Advantages of the sintercast:
1,No risk of casting breakage during operation
2,Original profile can be maintained for much longer time and due to which performance will be
consistent.
3,Sinter layer will be harder than hard facing layer and create uniform wear on the casting, it
reduces the power consumption
4,Reduce the stoppage for in situ hard facing and minimize the risk of production less and direct
revenue generation
5,Much less wear rate as compared to hard facing and twice or triple much higher wear life.
6,Reduce the maintenance and operating cost
